WINDOW / GLASS POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for the RH and LH sides.
·The procedure listed below is for the LH side.
·A bolt without a torque specification is shown in the standard bolt chart.
PROCEDURE
85720D
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.
- Torque:
- 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- HINT:
-
A new window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
69804
2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
68104
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
68124B
4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
67408E
5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
67842E
6.INSTALL REAR DOOR SERVICE HOLE COVER LH
67604
7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
74646A
8.INSTALL DOOR ASSIST GRIP COVER LH
69284D
9.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
10.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL LH
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
.png "close")